How to shutdown a CDOT 8.2+ NetApp

To shutdown the clustered filer connect via serial or RLM/SP to the first node, connect to the console (system console command)  and enter the command:

halt local -inhibit-takeover true -skip-lif-migration-before-shutdown 

Then, when at the LOADER prompt, connect to the second node and enter the command:

halt local -inhibit-takeover true -skip-lif-migration-before-shutdown 


Multi LUN Tape library on ESXi 5.1u2

If a tape drive comes up with VMW_SATP_ALUA rule in VMware vShpere (4.0 or later) you will most likely see input/output errors during backup operation on the VM you mapped to drive to. A working rule is VMW_SATP_LOCAL and you can change it using some simple steps.

Note: As this issue is related to the HBAs and tape drvies/changers used not all environments are affected.

  1. Find the module for SCSI/SAS HBA using esxcfg-scsidevs

    esx# esxcfg-scsidevs -a
    vmhba0 cciss link-n/a block.cciss/c0d0:0 (0:2:1.0) Compaq Computer Coporation Smart Array P400
    vmhba1 mptspi link-n/a pscsi.vmhba1 (0:7:1.0) LSI Logic / Symbios Logic ProLiant
    vmhba2 mptspi link-n/a pscsi.vmhba2 (0:7:1.1) LSI Logic / Symbios Logic ProLiant

  2. Add an additional rule for the HBA module the tape drive/changer is attached to

    esx# esxcli storage nmp satp rule add -s VMW_SATP_LOCAL -D=’mptspi‘ -e=’Tape drive support’

  3. Restart the ESX host to activate changes. The drive will now work as expected.
  4. Map the tape drive according to

Thanks to for the instructions about ESXi 4.x